DC Voltage-drop Calculator
Visualise cable losses for onboard DC circuits using copper area, length and current. Explore a live diagram, follow the step-by-step instructions, save a scenario and download your results.
Start planning ↓Explore losses along a DC cable
See how copper cross-section, cable length, current and conductor temperature affect voltage at the load.
- Enter DC supply voltage and expected steady current.
- Enter one-way cable length and copper area, not outer insulation diameter.
- Compare voltage drop at different cable sizes. Verify ampacity, fuses, terminals and installation separately.
The calculation doubles this for equal positive and negative conductors.
Further reading: Victron Energy: DC wiring
- Cable voltage drop
- 0.44 V
- Percentage drop
- 3.65 %
- Modelled load voltage
- 11.56 V
- Heat loss in both conductors
- 4.38 W
Copper model: 0.0175 Ω·mm²/m at 20°C, temperature coefficient 0.00393/°C. This is not a cable-sizing or fuse recommendation. It excludes connections, insulation rating, bundling and starting surges. Negative load voltage means the assumed current cannot be sustained by this model.
Example values are starting points. Replace them with your own figures. Saving is optional and stays on this device.
Planning aid only. Not for navigation. Check every result against official charts, tide predictions and forecasts, current conditions and your vessel’s requirements before acting on it.
How it works
Ohm’s law is applied to both conductors, with copper resistance adjusted for conductor temperature.
Voltage drop = current × 0.0175 × (1 + 0.00393 × (temperature − 20)) × 2 × one-way length ÷ area
Worked example
At 20°C, a 5 m one-way run of 4 mm² copper carrying 10 A loses 0.4375 V, or about 3.65% of 12 V.
Cable-only voltage-drop estimate; ampacity, protection, connection losses and installation requirements are separate.
Continue planning
Battery & Solar Budget →
Compare your onboard electricity use with solar generation and stored battery energy.
Departure Checklist Builder →
Create a trip-specific checklist, add your own checks and track completion.
Multi-leg Passage Planner →
Build a route timetable with individual leg speeds, stopovers and UTC arrivals.
