Under-keel Clearance Planner
Visualise charted depth, tide and loaded draft against your chosen clearance allowance. Adjust the inputs to compare scenarios, save on this device and download your results.
Start planning ↓See the space beneath your keel
Compare charted depth plus tide with your loaded draft, an extra allowance and your chosen minimum margin.
- Use charted depth and a tide height referred to the same vertical datum. Drying heights are negative depths.
- Enter loaded draft, then an allowance for effects not represented by static draft.
- Set your required margin and vary tide height. Review the shortfall and minimum tide needed.
Your allowance for squat, motion and uncertainty; not calculated automatically.
Further reading: AMSA: factors affecting under-keel clearance
- After additional allowance
- 0.9 m
- Above chosen minimum
- 0.4 m
- Minimum tide for this target
- 0.6 m
- Total water depth
- 3 m
The numbers meet your chosen target in this static model. Verify chart reliability, local restrictions, tide, waves, heel and squat before deciding whether to proceed. No universal safe margin is implied.
Example values are starting points. Replace them with your own figures. Saving is optional and stays on this device.
Planning aid only. Not for navigation. Check every result against official charts, tide predictions and forecasts, current conditions and your vessel’s requirements before acting on it.
How it works
Charted depth plus tide gives total water depth. Subtract loaded draft and your additional allowance, then compare with your chosen minimum.
Adjusted clearance = charted depth + tide - draft - allowance
Worked example
2 m charted depth plus 1 m tide, minus 1.8 m draft and 0.3 m allowance, leaves 0.9 m.
Use compatible vertical datums. Allowance is not a calculated squat or wave correction. The example margin is not an official or universal safety requirement.
Continue planning
Tide Height Explorer →
Explore an idealised rising or falling tide between two consecutive high/low events.
Departure Checklist Builder →
Create a trip-specific checklist, add your own checks and track completion.
Multi-leg Passage Planner →
Build a route timetable with individual leg speeds, stopovers and UTC arrivals.
