For house batteries on a boat, lithium means lithium iron phosphate, written LiFePO4 or LFP. It is the most stable of the common lithium chemistries and the one marine house banks use. It replaces lead acid, AGM and gel batteries.
The gains are real. So is the cost of doing it badly. A lithium bank dropped into a boat wired for lead acid can damage the alternator and will not give you the life you paid for.
What you gain
- More usable power. You can use most of a lithium battery's rated capacity day after day. With lead acid you should only use about half.
- Less weight. A lithium bank weighs roughly half as much as the lead acid bank it replaces, often less.
- Faster charging. Lithium takes high charge current almost until it is full, so engine and generator run times drop sharply.
- Longer life. A well treated lithium bank lasts for thousands of cycles. That is many years of full time cruising.
- Steady voltage. Fridges, autopilots and electronics see nearly the same voltage from full to nearly empty.
What it costs you
- A higher price up front. Over the life of the bank lithium usually works out cheaper per cycle, but you pay at the start.
- Changes to the charging system, covered below. Budget for these, not only the batteries.
- Lithium cannot be charged below freezing. In most of Australia that does not matter. In Tasmania in winter, or anywhere you lay up in the cold, it can.
How to size the bank
- List what you run and for how long each day: fridge, freezer, autopilot, instruments, lights, watermaker, inverter loads.
- Add it up in amp hours per day.
- A common target is a bank that covers one to two days of use with no charging. With lithium you can count almost all of the rated capacity.
- A boat that needed 400 amp hours of AGM often lives well on 200 to 300 amp hours of lithium.
What has to change on the boat
- Battery management system. Every lithium battery needs a BMS that stops overcharge, over discharge, and charging when too hot or too cold. Many batteries have one built in. The Australian and New Zealand standard for boat electrical installations requires one.
- Alternator. A lithium bank will take everything a standard alternator can give until it overheats. Fit an external regulator with temperature sensing, or a DC to DC charger between the start battery and the house bank.
- Chargers and solar controllers. Each one needs a lithium charge profile. Old chargers with only lead acid settings should go.
- Sudden disconnect. If the BMS cuts the battery off while the alternator is charging, the voltage spike can kill the alternator diodes. Your installer should design for this.
- Fuses and cable. Lithium can deliver enormous current into a short circuit. Use the right class of fuse close to the battery, and cable sized for the load.
- Start battery. Most boats keep a lead acid start battery and use lithium for the house bank only.
Safety and insurance in Australia
- Have it installed by a competent marine electrician to AS/NZS 3004.2, the standard for electrical installations on boats. It has specific requirements for lithium batteries.
- Tell your insurer before the work is done. Some ask for details of the battery, the BMS and who installed it.
- Buy a recognised brand with local support. Battery quality varies widely, and you cannot see inside the case.
- Mount the bank securely, away from heat, with room to inspect the terminals.
- Loose lithium items cause more boat fires than house banks do. Charge e-scooters, tool batteries and tender batteries where you can watch them, and never leave them charging on an empty boat.
Drop in or a designed system
- Drop in batteries are the same size as lead acid ones and carry their own BMS. They are the simple path for small and mid sized banks, as long as the charging side is still sorted.
- A designed system uses an external BMS that talks to the chargers, alternator regulator and inverter. It costs more and suits large banks and boats with heavy inverter loads.
What to ask before you buy
- What is the maximum continuous charge and discharge current, and will it start my inverter loads?
- What happens to my alternator if the BMS disconnects?
- Can the batteries be wired in parallel or series, and how many?
- What is the warranty, and who honours it in Australia?
Lithium, AGM or flooded lead acid
Lithium is not the right answer for every boat. Compare them on what you can use, not on the number printed on the case.
| Flooded lead acid | AGM or gel | Lithium (LiFePO4) | |
|---|---|---|---|
| Usable share of rated capacity | About 50% | About 50% | 80 to 90% |
| Cycle life, treated well | Hundreds | Several hundred to 1,000 | Thousands |
| Weight for the same usable power | Heaviest | Heavy | About a third |
| Charge speed | Slow, tapers early | Faster, still tapers | Fast almost to full |
| Upkeep | Top up water, vent | None | None, but needs a BMS |
| Price up front | Lowest | Middle | Highest |
| Suits | Weekend boats on a budget | Coastal cruisers who plug in often | Liveaboards and anyone on solar |
- Stay with AGM if the boat lives on shore power, you day sail, or the charging system is old and you do not want to rebuild it.
- Move to lithium if you live at anchor, run a fridge and autopilot every day, or weight matters.
- Do not mix types in one bank, and do not add new batteries to an old bank. The old ones drag the new ones down.
How the system fits together
Calculators
Work through these in order. The first gives your daily use, the second turns it into a bank size, the third tells you how much solar puts it back.
Calculator
Daily energy budget
Enter the amps each item draws and the hours it runs in a day at anchor or on passage.
- 78 Ah
- 0.9 kWh
Calculator
Battery bank size
How big a house bank you need for the days you want to last without charging.
- 230 Ah
- 90%
Calculator
Solar panel size
The panel wattage needed to put back what you use each day.
- 390 W
- 1,200 Wh a day
Battery monitors
A voltmeter tells you very little about a lithium bank, because the voltage barely moves between 90% and 20%. Fit a shunt based battery monitor that counts amp hours in and out. It is the cheapest part of the system and the one that stops you guessing.
The numbers on the label, explained
- Amp hours (Ah): capacity. A 100 Ah battery gives 5 amps for 20 hours on paper. Lead acid gives less at high currents; lithium barely changes.
- Watt hours (Wh): amp hours times voltage. Use it to compare 12 and 24 volt systems. 100 Ah at 12.8 volts is 1,280 Wh.
- C rate: charge or discharge current as a share of capacity. 0.5C on a 200 Ah battery is 100 amps. Most LiFePO4 batteries accept 0.5C charge and deliver 1C continuous. Check both.
- Cycle life: the number of charge and discharge cycles to a stated depth before capacity falls to 80%. Compare makers at the same depth of discharge.
- BMS limits: the current at which the battery protects itself and switches off. This, not the capacity, decides whether it will run your inverter or windlass.
- Low temperature cut off: whether the BMS blocks charging below freezing.
- Ingress rating: IP65 or better where there is any chance of spray or bilge water.
12 volt or 24 volt
Stay at 12 volts if the boat is wired for it and under about 12 metres. Consider 24 volts on a refit of a bigger boat with a large inverter, electric winches or a bow thruster: currents halve, cables get thinner and voltage drop stops being a fight. Mixed systems need a converter for the 12 volt electronics.
Charging sources compared
| Source | Good at | Limits | Notes |
|---|---|---|---|
| Solar | Silent daily top up at anchor | Space, shading, weather | The base load for most cruisers |
| Alternator | Fast bulk charge under way | Only while motoring | Must be protected with lithium |
| Shore charger | Full charge and maintenance | Only in a marina | Needs the right profile |
| Wind generator | Trade wind anchorages, passages | Noise, little output under 12 knots | A supplement, not a main source |
| Hydro generator | Ocean passages under sail | Drag, cost | Strong output above 5 knots |
| Generator | Big loads on big boats | Fuel, noise, upkeep | Often replaced by lithium and solar |
A sensible order of work
- Fit a battery monitor first and log a fortnight of real use.
- Cut the load: LED lights, fridge insulation and door seals, switch the inverter off when idle.
- Add solar until it covers a normal day.
- Then size the bank for the gap, and sort the alternator.
Boats that do it in that order usually buy a smaller bank than they first planned.
When it is not worth it
A boat that day sails from a marina, with a fridge that runs only on shore power, gains almost nothing from lithium. Spend the money on sails.
Common questions
Can I just swap my AGM batteries for drop in lithium? Physically yes. Electrically, only if the alternator is protected and every charger has a lithium profile. Skipping that step is how alternators burn out.
How long do boat batteries last? Flooded and AGM banks on cruising boats typically last three to six years. A well treated lithium bank should last more than ten.
Do I need a separate start battery? Yes. Keep a lead acid start battery, charged from the alternator, and keep the house bank separate. Then a flat house bank never stops you starting the engine.
Is lithium safe on a boat? Lithium iron phosphate is the stable chemistry. The fires in the news are mostly other chemistries in scooters, tools and cheap packs. A quality LiFePO4 bank with a BMS, correct fusing and a competent install is a low risk.
Tutorials
The step by step guides for this upgrade are listed at the top of this page and in the sidebar: sizing a bank, planning a lithium conversion, protecting the alternator, wiring and fusing, and looking after the bank.
