Batteries store enough energy to weld. Wiring and fusing are what stand between a fault and a fire. If you are not confident with this work, use a marine electrician and use this page to check what you are quoted.
Step 1: size the cable for the current
Size the main cables for the largest continuous current, usually the inverter or windlass. Then check voltage drop over the full run.
Calculator
Cable voltage drop
Check a cable is heavy enough for its run before you pull it.
- 0.53 V
- 4.4%
- Too much for electronics, acceptable for lights
Step 2: fuse at the battery
- Every positive cable leaving the bank needs a fuse, as close to the battery as the cable allows.
- A fuse protects the cable. Rate it at or below what the cable can carry.
- Lithium can push thousands of amps into a short circuit. Use a fuse with a high interrupt rating. Class T is the usual choice for a lithium bank.
Step 3: wire parallel batteries evenly
When batteries are in parallel, take the positive from one end of the bank and the negative from the other, or bring equal length cables to a busbar. Otherwise the nearest battery does most of the work and wears out first.
Step 4: use busbars, not stacked lugs
More than two lugs on a battery post is a loose connection waiting to happen. Bring the loads to a busbar.
Step 5: make proper terminations
- Tinned marine cable, with lugs crimped by a proper tool and sealed with adhesive heat shrink.
- No solder alone. It cracks with vibration.
- Tighten to the torque the battery maker gives, and check again after a week.
Step 6: fit a switch and a shunt
A main isolator lets you kill the bank fast. The battery monitor's shunt goes in the negative, with nothing bypassing it.
Step 7: secure and cover
Strap batteries so they cannot move in a knockdown. Cover the positive terminals. Keep the box clear of fuel and of anything that can chafe.
Check your work
Run the biggest load for ten minutes, then feel every connection. Anything warm is a bad joint.
Tools and parts to have ready
- Hydraulic or hammer crimper sized for the lugs. Pliers will not do it.
- Tinned marine cable, tinned copper lugs, adhesive lined heat shrink
- Main fuse and holder rated for the battery fault current
- Torque wrench and the terminal torque from the battery maker
- Insulated spanner, terminal covers, cable ties and saddles
- Multimeter, and a clamp meter if you can borrow one
Choosing the cable size
Size the cable for two things: the current it must carry without overheating, and the voltage drop over the run. On a 12 volt boat, drop is usually the limit. Aim for 3 percent or less on charging circuits and anything electronic. Measure the full run, there and back. Then go up one size if the cable passes through the engine bay, because hot cable carries less.
Calculator
Cable voltage drop
Check a cable is heavy enough for its run before you pull it.
- 0.53 V
- 4.4%
- Too much for electronics, acceptable for lights
Mistakes to avoid
- Putting the fuse at the switchboard end. It belongs within a few hundred millimetres of the battery positive, because it protects the cable.
- Stacking four lugs on one terminal. Use a busbar.
- Leaving out the negative busbar and joining negatives at a battery post.
- Using automotive cable. Untinned copper turns black inside the insulation within a few seasons at sea.
- Wiring parallel batteries so one does all the work. Take positive from one end of the bank and negative from the other.
Test before you close it up
With the fuse out, check for continuity where there should be none. Fit the fuse, switch on one load at a time and feel each joint after ten minutes under load. A warm lug is a bad crimp. Measure voltage at the battery and at the furthest load with everything running. If the difference is more than you planned for, find the joint that is causing it now, not at sea.
