A diesel will not run with air in its fuel lines. Any time the system is opened, or the tank runs low enough to suck air, it must be bled. Learn where your bleed screws are in harbour, not at night in a seaway.
Before you start
- Find the bleed points in the engine manual and mark them with paint.
- Many modern engines bleed themselves once the low pressure side is primed. Check whether yours does.
- Have rags and a container ready. Diesel in the bilge must be cleaned up, not pumped overboard.
Step 1: check there is fuel
Tank has fuel, the shut off valve is open, and the primary filter bowl is full with no water in it.
Step 2: bleed the primary filter
Open its bleed screw and work the priming pump or the lift pump lever until fuel runs out with no bubbles. Close the screw while fuel is still flowing.
Step 3: bleed the engine filter
Open the bleed screw on top of the secondary filter. Pump the manual lever on the lift pump until clear, bubble free fuel flows. Close it.
If the lever feels dead, turn the engine over a quarter turn by hand. The lift pump cam is at the top of its stroke.
Step 4: bleed the injection pump
If your engine has a bleed screw on the injection pump, repeat the process there.
Step 5: the injectors
Usually not needed. If the engine still will not fire, loosen the pipe nut at each injector one turn, turn the engine on the starter with the throttle open until fuel spits from each, then tighten. Keep hands and face clear. Fuel at injection pressure can pierce skin.
Step 6: start
Give it half throttle. It may run rough for a few seconds as the last air clears.
Protect the starter and the engine
- Crank for no more than 10 to 15 seconds at a time, with a pause between.
- On a boat with a water lift exhaust, long cranking fills the muffler with water and can flood the engine. Close the raw water seacock while cranking and open it the moment it fires.
If air keeps coming back
There is a leak on the suction side: a loose filter bowl, a cracked hose, or a pick up tube sucking air when the tank is low.
Tools to have ready
- The spanners that fit your bleed screws, kept in a bag tied near the engine
- Rags and a small container to catch fuel
- Disposable gloves
- A torch you can hold in your teeth or a head torch
- Spare copper washers for the bleed screws and banjo bolts
Know your engine before you need to
Many modern small diesels bleed themselves if you crank them with the throttle open, or have an electric lift pump that does it for you. Older engines need each stage opened in turn. Read the manual at the dock and find every bleed point with your finger. Mark them with a dab of paint. In a seaway at night you will not find a bleed screw you have never seen.
Mistakes to avoid
- Cranking for a minute at a time. You will flatten the start battery and can fill the exhaust with sea water. Crank in short bursts and close the raw water seacock if it takes many attempts. Open it again the moment the engine fires.
- Overtightening bleed screws. They are small and they strip.
- Bleeding without fixing the cause. Air got in somewhere: an empty tank, a loose filter bowl, a cracked hose, a clogged tank vent.
- Leaving diesel in the bilge. Mop it up.
If it still will not run
Work backwards. Is there fuel in the tank and is the tank valve open? Is the primary filter bowl full? Does fuel come out of the lift pump when you work it? If fuel reaches the injection pump with no bubbles and the engine still will not fire, the problem is no longer air. Check the stop control has returned to run.
