Two filters protect the engine. The primary, with its water separating bowl, sits between the tank and the engine. The secondary is on the engine itself. Change both every year or every 200 hours, and at once if the engine starts to hunt or lose power.
What you need
- The correct elements and new seals for both filters.
- A drain tray, rags, absorbent pads, a bag for the old elements.
- Clean diesel in a clean container for prefilling.
- Gloves.
Step 1: shut off the fuel
Close the valve at the tank.
Step 2: primary filter
- Open the drain on the bowl and let fuel and any water run into the tray. Look at what comes out. Water sits at the bottom. Black or brown slime is diesel bug.
- Remove the bowl or the element, depending on type.
- Wipe the housing clean. Fit the new element and new seals, lightly oiled with diesel.
- Fill the housing with clean diesel if the design lets you. It makes bleeding much quicker.
Step 3: secondary filter
- Put a bag around it and unscrew.
- Oil the new seal, fill the new filter with clean diesel if it is a spin on type, and fit it hand tight.
Step 4: open the fuel and bleed
Open the tank valve and bleed the system. The bleeding tutorial in this section covers it.
Step 5: run and check
Run the engine for ten minutes under load, in gear at the dock. Check both filters for weeps.
Reading what you find
- A little water in the bowl each time: normal condensation. Drain it monthly.
- A lot of water: a leaking deck filler seal, or bad fuel.
- Slime: diesel bug. Treat the tank with a biocide, change filters again after a few hours of running, and plan to have the tank cleaned.
Good habits
- Buy fuel from busy suppliers.
- Check the deck filler O ring each year.
- Keep tanks full over winter.
- Fit a vacuum gauge on the primary filter. It shows a blocking filter long before the engine stops.
- Carry at least two spare sets. One bad tank of fuel can use them both in a day.
Tools and parts to have ready
- Primary filter element of the right micron rating, and the secondary filter for your engine
- New O rings and seals. They usually come in the box. Use them.
- Clean diesel in a small bottle to pre fill the filters
- Filter wrench, drip tray, absorbent pads, gloves
- A jar to look at what came out of the bowl
Which micron rating
The primary filter sits between the tank and the lift pump and takes out water and the bigger dirt. The secondary filter on the engine is the fine one. A common arrangement is 30 micron primary and the engine maker fine filter after it. Fitting a very fine primary feels safer but it blocks sooner and starves the engine in rough water, when the tank is stirred up. Follow the engine maker advice.
Read what comes out
| What you see in the bowl | What it means |
|---|---|
| Clear diesel | Healthy |
| Water layer at the bottom | Leaking deck filler seal or condensation. Drain more often and find the source |
| Black or brown slime | Diesel bug. Treat the tank and expect to change filters again soon |
| Rust flakes or grit | Tank is breaking down or was filled from a dirty supply |
Mistakes to avoid
- Fitting the filter dry and then cranking for minutes to pull fuel through.
- Reusing the old seal, or leaving the old seal stuck in the housing under the new one.
- Overtightening a spin on filter. Hand tight plus a quarter turn is usual.
- Carrying one spare. If you have diesel bug, the first replacement can block within hours. Carry at least three primary elements on a long trip.
After the change
Bleed the system, run the engine under load for fifteen minutes and look at every joint you opened with a dry finger. A weep that lets fuel out will let air in. Check again after the first hour of motoring.
