The impeller is a rubber wheel that pumps seawater through the engine. Run it dry for a minute and it sheds vanes. Carry two spares and know where the pump is before you need to.
Signs it has failed
- No water, or much less water, from the exhaust.
- A change in the exhaust note to a dry, hollow bark.
- Temperature alarm. Stop the engine as soon as you see any of these.
What you need
- The right impeller and a cover gasket or O ring.
- Screwdriver or spanner for the cover, long nose pliers or an impeller puller.
- A little glycerine or dish soap. Not grease on a rubber impeller.
Steps
- Stop the engine and close the raw water seacock.
- Put a rag or tray under the pump and remove the cover plate.
- Note which way the vanes are bent.
- Pull the impeller out. Two pairs of pliers on opposite vanes, or a puller. Do not lever against the pump body; it is soft bronze.
- Count the vanes. If any are missing, they are downstream, usually at the inlet of the heat exchanger. Remove that hose or end cap and get them out. Leaving them there causes overheating later.
- Check the cover plate and the cam for scoring.
- Smear the new impeller with glycerine or soap, and push it on with a twist in the direction of rotation.
- Fit the new gasket and the cover.
- Open the seacock.
- Start the engine and look for water at the exhaust within 10 to 15 seconds.
If there is still no water
- Seacock open?
- Strainer blocked, or its lid not sealed and sucking air?
- Hose collapsed or kinked on the suction side?
- A plastic bag over the intake outside the hull?
Prevent the next one
- Change the impeller every year whatever it looks like.
- Check the strainer before every start.
- If the boat has been out of the water, or the engine has stood for months, expect the impeller to have taken a set. Check it.
- Tape a spare impeller and the tools to the engine box.
Tools and parts to have ready
- The right impeller for your pump, plus the gasket or O ring
- Impeller puller, or two flat screwdrivers and some patience
- Screwdriver or socket for the cover plate, and spare cover screws
- Glycerine or dish soap to lubricate the new impeller. Not grease, unless the maker says so.
- Torch, mirror, rag and a small container for the screws
How to tell it needs doing
- Less water than usual at the exhaust, or steam
- Temperature creeping up at cruising revs
- A change in the exhaust note to a dry, hollow sound
- Blades that have taken a permanent bend, are cracked at the root, or are missing
If the engine has overheated for any reason, change the impeller afterwards even if it looks fine. Running dry for thirty seconds can finish it.
Mistakes to avoid
- Not closing the seacock first, or not opening it afterwards.
- Fitting the impeller dry.
- Ignoring the cover plate. If it is scored, flip it or replace it, because a worn plate lets the pump lose prime.
- Losing a screw in the bilge with no spare aboard.
- Leaving broken blade pieces downstream. Check the hose to the heat exchanger and the end cap.
How long it takes
Ten minutes on an engine with the pump at the front. An hour and some bad language on an engine where the pump faces the bulkhead. Do it once at the dock on a calm day so the first time is not at sea in a swell. If access is truly bad, a remote cover kit or a speed seal style cover is worth looking at.
