An AIS transceiver is one of the best safety buys for a yacht. The install is a weekend job if you plan the antenna first.
Step 1: choose the unit
- A transceiver, not a receiver. Being seen matters more than seeing.
- Class B units using the newer SOTDMA scheme transmit more often and at higher power than older Class B. Worth the difference if you sail among shipping.
- Built in splitter and Wi-Fi are conveniences, not necessities.
Step 2: get your MMSI
In Australia an MMSI is issued by the Australian Maritime Safety Authority. The same number goes into your DSC radio. Enter it carefully: on most units it can only be programmed once by the owner.
Step 3: sort the VHF antenna
- Best: a dedicated AIS antenna, mounted at least a metre from the main VHF antenna, on the pushpit or a spreader.
- Simplest: a proper AIS splitter sharing the masthead VHF antenna. Use one made for transceivers, not a cheap receive only splitter.
- Use good coax and as few joins as possible.
Calculator
VHF and AIS range
VHF and AIS reach only a little past the horizon, so antenna height sets the range.
- 20 nm
- 12 nm
Step 4: fit the GPS antenna
The transceiver needs its own GPS antenna with a clear view of the sky. Under deck mounting works on some fibreglass boats; check the manual. It will not work under a metal or carbon deck.
Step 5: power and network
- Power through its own fuse, switched so it can stay on when the plotter is off.
- Connect to the plotter by NMEA 2000.
- Many units have a silent switch to stop transmitting while still receiving.
Step 6: program the vessel details
Name, call sign, MMSI, vessel type and dimensions, including where the GPS antenna sits. Wrong dimensions put your boat in the wrong place on a ship's screen.
Step 7: test
- Check the unit's status lights show transmit, not only receive.
- Look yourself up on a public AIS tracking site, or ask a nearby boat what they see.
- On the plotter, set a CPA alarm you will act on. One mile and 10 minutes is a common starting point; tighten it in busy harbours.
Remember
AIS shows only vessels that transmit. Keep looking out.
How it connects
Receiver or transponder
| Receive only | Class B transponder | |
|---|---|---|
| You see ships | Yes | Yes |
| Ships see you | No | Yes |
| Needs an MMSI | No | Yes |
| Needs its own GPS antenna | No | Yes |
Newer Class B units using the SOTDMA scheme transmit more often and with more power than older ones, which helps in busy water. For most cruising boats a transponder is the one to fit.
Antenna choices
You have three options. A dedicated VHF antenna for AIS gives the best result but needs a second cable run and at least a metre of separation from the main VHF antenna. A splitter lets AIS share the masthead VHF antenna, which gives the best range and saves a cable, but use a proper active splitter made for transponders. A rail mounted antenna is the easiest and gives the least range. Range depends on height.
Calculator
VHF and AIS range
VHF and AIS reach only a little past the horizon, so antenna height sets the range.
- 20 nm
- 12 nm
Programming it
A transponder must be programmed with your MMSI, boat name, call sign, dimensions and the position of the GPS antenna on the boat. In many units the MMSI can only be entered once, so check every digit. In Australia the MMSI comes from AMSA. Use the same MMSI as your DSC radio.
Mistakes to avoid
- Putting the GPS antenna under a solar panel or radar.
- A passive splitter or a TV type splitter. It can damage the unit.
- Forgetting the silent switch setting. Know whether you are transmitting.
- Not checking with another boat or a marine traffic site that you actually appear.
- Treating AIS as radar. Small boats, fishing boats and many others do not transmit.







