A cruising boat with only a main and a genoa is slow and rolly below about 12 knots off the wind. A downwind sail fixes that. Choose by the angles you sail and who handles it.
The choices
| Sail | Best wind angle | Handling | Suits |
|---|---|---|---|
| Asymmetric spinnaker | 90 to 150 degrees | Sock or top down furler, no pole | Most cruising couples |
| Code zero | 50 to 110 degrees | Furler on a bowsprit or bow fitting | Light air reaching, motoring less |
| Symmetric spinnaker | 130 to 180 degrees | Pole, guys and more crew | Racing crews and dead downwind routes |
| Twin poled out headsails | 150 to 180 degrees | Two poles, furls from the cockpit | Trade wind passages |
Step 1: decide the angles
Coastal sailing in sea breezes is mostly reaching: an asymmetric covers it. Long ocean runs with the wind astern favour twins or a symmetric.
Step 2: decide the handling
- A sock is cheap and simple. Someone goes to the foredeck to hoist and douse it.
- A top down furler lets you set and furl from the cockpit. It costs more and needs a torsion rope and a proper tack point.
- Whatever you choose, the sail must be easy to get down in a hurry. That decides whether you use it.
Step 3: check the boat
- A strong tack point ahead of the forestay: a short bowsprit or a rated bow fitting.
- A spinnaker halyard above the forestay, on a swivel block.
- Sheet blocks well aft, and winches free.
Step 4: size and cloth
Cruising asymmetrics are cut smaller and flatter than racing ones, and in heavier nylon. Tell the sailmaker the wind range you will carry it in. Most cruisers fly them from 5 to about 15 knots of true wind.
Step 5: learn the take down
Practise in light air. Bear away to blanket the sail behind the main, ease the tack line or sheet, then sock or furl. Never try to douse it while reaching in a gust.
The honest answer
For a cruising couple the first downwind sail is an asymmetric in a sock. Add a furler or a code zero later if you find you use it.
Handling gear you will need
- A spinnaker halyard that exits above the forestay, on a swivel block
- Sheets about twice the boat length, light enough to let the sail fly in soft air
- A tack line led aft for an asymmetric, so the luff can be eased or tightened from the cockpit
- Turning blocks well aft, and winches free for the sheets
- A snuffer or sock for short handed crews, or a top down furler for a furling asymmetric
- For poled out headsails: a pole of the right length, with a topping lift, foreguy and afterguy so the pole stays put when the sail collapses
Snuffer or furler
A snuffer is a fabric tube that slides down over the sail. It is simple, cheap to maintain and works with the sail you already have, but someone goes to the foredeck to pull it down. A top down furler rolls the sail around a torsion rope from the cockpit. It is quicker and keeps the crew aft, but it adds cost and hardware, and a bad furl in a rising breeze is hard to sort out. For a couple cruising offshore, either is better than a bare sail.
When to take it down
Decide your wind limit before you hoist and stick to it. For most cruising boats a light nylon sail comes down somewhere around 15 to 18 knots of true wind, earlier at night or with a small crew. Remember that running downwind hides the real wind strength: 18 knots true feels like 11 over the deck at 7 knots of boat speed. Take the sail down by bearing away so it is blanketed behind the mainsail, then snuff or furl, then lower.
Mistakes to avoid
- Hoisting for the first time on passage. Practise in 8 knots on a quiet afternoon.
- No preventer on the boom when running deep.
- Sheets with knots in the ends. A spinnaker sheet must be able to run free if things go wrong.
- Carrying it into dusk because it is going well.
- Leaving the sail stuffed wet in its bag. Nylon mildews and the colours run.
A sensible first choice
For most cruising couples the order is: a pole for the genoa first, because it costs little and works in a breeze; then an asymmetric with a snuffer for light and moderate reaching and running. A symmetric spinnaker or a purpose built twin headsail rig is worth it only if you sail long trade wind passages or enjoy the work.
