Sails die of four things: sun, flogging, chafe and being put away wet and salty. All four are habits.
Sun
- Cover the mainsail every time you leave the boat, even for a day.
- Furl the headsail so the UV strip covers all the cloth. If a triangle of white shows, the strip or the furl is wrong.
- In the tropics or for a long stay, take the headsail off the furler.
Flogging
- Flogging breaks down cloth and stitching faster than anything else. A few minutes does real damage.
- Hoist and drop sails with the boat pointing so they luff quietly, not thrash.
- Tension the leech line just enough to stop flutter, and ease it afterwards.
- Do not motor to windward with the main up and shaking. Sheet it in or drop it.
Chafe
- Fit spreader patches and stanchion patches where the sail touches.
- Tape split pins, rings and anything sharp on the rig.
- On passage, check the sail against the shrouds and spreaders every watch when running.
Salt and damp
- Rinse with fresh water when you can and dry before stowing for long periods.
- Salt holds moisture, and damp sails grow mildew. Laminates suffer most.
- Never store a wet sail in a bag in a hot locker.
Folding and storage
- Flake woven sails loosely, changing the fold lines each time.
- Roll laminate sails rather than folding them.
- Store dry, cool and away from rodents.
Washing
- Soak in fresh water with a mild soap and rinse well. No machine, no hot water, no bleach on laminates or nylon.
- Rust and mildew stains are a job for the sailmaker.
Each winter
Take the sails to a sailmaker for a check and restitch. They will resew the leech and UV strip, replace worn webbing and slides, and tell you honestly how many seasons are left. It costs a small fraction of a new sail and commonly adds years.
What wears sails out
| Cause | What it does | What to do |
|---|---|---|
| Sunlight | Breaks down cloth and thread | Covers on, UV strip in good order, sails off when the boat is left for months |
| Flogging | Breaks the fibres and the resin in the cloth | Do not motor head to wind with sails flapping. Reef early |
| Chafe | Wears holes at spreaders, stanchions and lazy jacks | Patches, spreader boots, check sheet leads |
| Salt and damp | Mildew, stiff cloth, corroded fittings | Rinse with fresh water, dry before stowing |
| Overload | Stretches the shape permanently | Use the sail in its wind range |
A yearly routine
- Start of season: check stitching along the leech and at the corners, check battens and slides, check the cover fits.
- During the season: rinse after a hard salty sail, ease the halyard and outhaul when you leave the boat, roll the genoa tightly with the UV strip outside.
- End of season: wash, dry fully, send to the sailmaker for a check, and store loosely rolled or flaked somewhere dry.
Mistakes to avoid
- Leaving a furled genoa up through a storm at the dock. Take it down or wrap it with a spare halyard.
- Flaking on the same folds every time.
- Stowing a wet spinnaker in its bag for a week.
- Putting off the sailmaker visit. A yearly check costs little and catches thread failure before a seam opens.
