Small outboards are simple and they live a hard life: salt, sun, stale fuel and long idle spells. An hour a year keeps one starting on the second pull. Use your model's manual for quantities and part numbers.
The habit that matters most
Stale fuel blocks the tiny jets in a small carburettor. Before the motor sits for more than a couple of weeks, turn the fuel off and let it run until it stops. Use fresh fuel, and a stabiliser if it will sit.
After every use in salt water
Flush with fresh water for a few minutes, using flushing muffs or a bucket, and rinse the outside. Tilt it down to drain.
Yearly service
Engine oil
- Warm the engine, then drain or pump out the oil.
- Refill with the marine four stroke oil specified, to the mark.
- Milky oil means water is getting in. Find out why.
Gearbox oil
- Remove the lower drain screw, then the upper vent screw.
- Milky or metallic oil means failed seals. Fix before use.
- Refill from the bottom hole until oil comes out of the top, fit the top screw, then the bottom, with new washers.
Spark plug
Remove, check the colour and the gap, and replace it. Light tan is healthy. Black and oily is not.
Water pump impeller
Replace every two to three years, or yearly if you run in sand and shallows. A weak tell tale stream is the warning.
Anodes
Replace when half gone. Never paint them.
Fuel
- Replace the inline filter if fitted.
- Check the fuel hose and primer bulb for cracks.
- Empty and clean the tank of old fuel.
Grease and protect
- Grease the tilt pivot, the steering pivot and the clamp screws.
- Check the propeller for line around the shaft and for dings. Grease the shaft.
- Spray the powerhead lightly with corrosion inhibitor.
Kill cord and pull cord
Check the kill switch stops the engine. Replace a frayed pull cord before it breaks.
If it will not start
Dropped it in the water?
Do not try to start it. Rinse with fresh water, remove the plug, pull it over to clear water, flood the cylinder and carburettor with oil or fogging spray, change the oil, and get it running or to a mechanic within hours. Left overnight, it is scrap.
Tools and parts to have ready
- Gear oil and a pump or tube that fits the lower unit, with new drain screw washers
- Engine oil and filter for a four stroke
- Spark plug and plug spanner
- Water pump impeller kit
- Marine grease, corrosion spray, a new anode
- Fresh fuel, fuel stabiliser, an inline fuel filter
- Flushing muffs or a drum of fresh water
How often
| Job | When |
|---|---|
| Flush with fresh water | After every use in salt water if you can |
| Check oil level, four stroke | Every use |
| Gear oil | Yearly. Sooner if it comes out milky |
| Engine oil and filter, four stroke | Yearly or every 100 hours |
| Spark plug | Inspect yearly |
| Impeller | Every two to three years |
| Anode | Replace at half worn |
| Grease the swivel, tilt and throttle points | Twice a season |
Fuel is most of the trouble
Small outboards mostly fail because of old fuel. Petrol goes off in a few months and leaves varnish in the tiny jets of a small carburettor. Use fresh fuel, add stabiliser if it will sit, and run the carburettor dry or drain it before leaving the engine for more than a few weeks. Keep water out of the tank. If the engine hunts, stalls at idle or only runs on choke, clean the carburettor before you blame anything else.
If it has been underwater
A dunked outboard has to be dealt with the same day. Rinse it with fresh water, take the plug out, pull the starter to push water out, drain and flush the carburettor, change the oil on a four stroke, spray fogging oil into the cylinder and get it running. An engine that sits wet with salt water inside for a day or two is usually finished.
Mistakes to avoid
- Running it out of the water with no cooling supply, even briefly.
- Carrying a four stroke on the wrong side. Oil runs into the cylinder. The correct side is marked on the engine.
- Reusing drain screw washers on the gearbox.
- Forgetting the kill cord clip when it will not start.











