An inflatable lifejacket is a machine. It has a gas cylinder, a firing mechanism and a bladder, and any of them can fail quietly in a locker. Check each jacket at the start of the season and after any time it gets soaked. This does not replace the maker's service.
What you need
- A dry, clean table.
- The maker's instructions for your model.
- A kitchen scale.
- A spare rearming kit for your model, in case you find a fault.
Step 1: outside
- Cover, stitching and webbing: no cuts, fraying or sun damage.
- Buckles and adjusters work and hold.
- Crotch or thigh straps fitted. Without them the jacket rides up over your head in the water.
Step 2: open it up
Undo the cover carefully and note how it was folded. Take a photo.
Step 3: cylinder
- Unscrew the cylinder. Check the end is not pierced.
- No rust or pitting.
- Weigh it. The minimum gross weight is stamped on the cylinder. If it is under, replace it.
- Screw it back hand tight. A loose cylinder is the most common fault found.
Step 4: firing head
- Automatic models have a water sensitive capsule or a hydrostatic unit with an expiry date. Replace it if out of date.
- Check the indicators show green.
- The manual pull cord is free and its toggle hangs outside the cover.
Step 5: bladder
- Inflate by mouth through the oral tube until firm.
- Leave it for 24 hours. It should still be firm.
- Look for chafe and check the oral valve seals.
- Deflate by pressing the valve with the cap reversed. Squeeze all the air out.
Step 6: fittings
- Light: test it and check the battery date.
- Whistle attached.
- Spray hood present and intact.
- Harness loop and stitching sound if it is a harness model.
Step 7: repack
Fold exactly as the maker shows, with the pull toggle outside. Write the date inside the cover.
When to stop and send it in
A bladder that loses air, a corroded cylinder, damaged webbing or any doubt about the firing head. Use an authorised service agent.
Reading the cylinder
The gross weight is stamped on the cylinder. Weigh it. If it is more than a couple of grams under the stamped figure, replace it. Look at the end: a pierced cylinder has a hole in the seal and is empty, whatever it weighs in your hand. Any rust, pitting or damage to the thread means replace. Cylinders are not interchangeable between sizes of jacket. The size is on the jacket label.
Manual, automatic and hydrostatic
| Type | How it fires | What to check |
|---|---|---|
| Manual | You pull the toggle | Cylinder, green indicator clip, toggle free |
| Automatic, soluble bobbin | Water dissolves a bobbin | Bobbin date and condition, cylinder, indicator |
| Hydrostatic | Water pressure a little under the surface | Expiry date on the unit, indicator green |
Bobbins and hydrostatic units have expiry dates. Replace on the date, not when they look tired.
Mistakes to avoid
- Screwing the cylinder in loosely. Hand tight, firmly, and check it again during the season because they work loose.
- Storing jackets wet in a locker. Damp can fire an automatic jacket and rots the fabric.
- Skipping the overnight inflation test.
- Assuming self service is enough. Many makers and some state rules call for professional servicing at set intervals. Check the label and your state rules.
Fit matters as much as service
Put each jacket on the person who will wear it, over wet weather gear. Tighten it until a fist only just fits under the belt. Fit and use the crotch strap. Without one, the jacket rides up over your face in the water. A serviced jacket that comes off over your head has done nothing.











