A membrane left wet and still grows bacteria and slime that block it for good. Pickling replaces the water inside with a preservative solution. Follow your maker's instructions where they differ from this outline.
When to pickle
- Flushing with fresh water protects for about a week in warm water, longer in cold.
- Pickle if the unit will not run for more than three to four weeks.
- Pickle before any lay up where the boat could freeze, and add the maker's antifreeze step if they give one.
What you need
- The maker's preservative, in the amount stated for your membrane size.
- A clean bucket and unchlorinated fresh water. Product water is best.
- The service hoses or valves your unit uses to draw from a bucket.
- Gloves and eye protection. The usual preservative is an irritant.
Steps
- Flush the system with fresh water first.
- Mix the preservative in the bucket exactly as the label says.
- Set the service valves so the feed pump draws from the bucket and the brine returns to it.
- Open the pressure valve fully. Pickling is done at no pressure.
- Circulate for the time stated, usually 10 to 20 minutes.
- Stop the pump, close the seacock, and leave the solution in the unit.
- Label the unit with the date.
How long it lasts
Most preservatives protect for six months to a year. Check the label and repeat if the lay up runs longer.
Bringing it back
- Open the seacock and run on seawater with the pressure valve open for several minutes to clear the solution.
- Bring it up to pressure and dump the product water for 20 to 30 minutes.
- Test before sending water to the tank.
Mistakes to avoid
- Using tap water with chlorine in it to mix or flush. Chlorine destroys membranes.
- Pickling a dirty system. Change the pre filters first.
- Forgetting it was pickled and filling the tank with the first run.
The flush circuit
Flush or pickle
| How long it will sit | What to do |
|---|---|
| Up to about 5 to 7 days | Fresh water flush after the last run |
| A few weeks, if you can get aboard | Fresh water flush every 5 to 7 days |
| A month or more | Pickle with the storage chemical |
| Over winter where it can freeze | Pickle with a food grade antifreeze mix as the maker directs |
These are typical figures. Warm water shortens them. Follow your manual.
How long pickling lasts
A pickled membrane is normally good for about six months in a temperate climate, less in the tropics. If the boat will sit longer, flush and pickle again. Write the date on a label at the control panel so nobody starts the unit and sends storage solution to the tank.
Bringing it back into service
Open the seawater intake, set the valves so product water goes overboard, and run the unit unpressurised for a few minutes to clear the chemical. Bring the pressure up slowly and run for at least 20 to 30 minutes, discarding all the product water. Test salinity and taste before sending water to the tank. Replace the prefilters while you are there.







